1998 ISUZU HOMBRE 2DR PICKUP
Security
Battery RED ORG + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger GRY/BLK (-) (-) BEHIND DASH ABOVE KICK PANEL
TrunkTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights LT.BLU (+) AT LIGHT SWITCH
Remote Start
Battery RED ORG + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 BRN + (+) IGNITION SWITCH HARNESS
Ignition03 WHT + IGNITION SWITCH HARNESS (TRANSMISSION)
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftType RESISTOR BASED SYS
AntiTheftSystem PASSLOCK II
KeySense LT GRN (-) STEERING COLUMN HARNESS
NeutralSafety NOT GRDING
Tach WHT (-) (-) AT COIL POER CONTROL MODULE
SpeedSense GRN/WHT 4000 (AC) PASS FRT QTR BLK 80 PIN CONN POS 16
ParkingLights LT.BLU (+) AT LIGHT SWITCH
BrakeLights WHT (+) AT BRAKE SWITCH
ReverseLights GRY (+) AT SWITCH ON TRANSMISSION
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock BLK (+) BEHIND DRIVERS DASH ABOVE KICK PANEL
PowerLock LT.BLU (+) POSITIVE DOOR LOCKS
LeftFrontWindow01 LF:DK.BLU
RightFrontWindow01 RF:LT.BLU AT SWITCH
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN, AT SWITCH
Convenience
HeadLights WHT (+) AT LIGHT SWITCH
LowSpeedWipers VIO (+) AT LIGHT SWITCH
TrunkRelease BLK/WHT (+) ABOVE DRIVERS KICK
Mobile Audio / Video
Battery RED ORG + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
